FD60 fire doors in Rochester, ME1

Getting FD60 fire doors right in Rochester

Our FD60 fire doors service covers Rochester and the wider Kent area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Buildings in and around Rochester range from small blocks of flats to houses with integral garages and light industrial buildings. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

FD60 openings in Rochester buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. Before ordering FD60 doors for a Rochester building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer.

When does a building need FD60 rather than FD30?

FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.

We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.

On a typical job that means:

• Check of the fire strategy rating for each opening
• Certified FD60 doorset or leaf with matching evidence
• 60-minute glazing systems where vision panels are needed
• Frame fixing and structural gap sealing recorded with photos

Which fire door rules apply in Rochester?

In Rochester, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Rochester building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Who needs FD60 fire doors in Rochester?

From plant and boiler rooms to stair cores in taller blocks, the requirement for FD60 fire doors in Rochester comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.

How a Rochester job runs

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Guide prices in Rochester

Guide pricing for FD60 fire doors: £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. Volume work across several doors in one Rochester building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Covering Rochester and nearby

Rochester is about 13.5 km from Maidstone, and we cover both, along with nearby Chatham and Strood. Send us your postcode and we'll confirm survey dates.

Questions