FD60 fire doors in Canterbury

FD60 fire doors in Canterbury, done to the evidence

If you need FD60 fire doors in Canterbury, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.

Around Canterbury, high-street shops, low-rise blocks of flats and care homes all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

Before ordering FD60 doors for a Canterbury building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Canterbury we generally fit certified doorsets, so frame and leaf share the same test evidence.

Why FD60 installation is less forgiving

A 54mm leaf can weigh considerably more than a 44mm one. That weight drives everything else: more robust frames and fixings, hinges rated for the load, and a closer with enough power to close and latch the door without making it too heavy to open. Glazing, if any, must use a 60-minute glass and glazing system from the same test evidence.

Because of this, most FD60 openings are best done as a certified doorset, so the frame and leaf come with matching evidence.

What you get:

• 60-minute glazing systems where vision panels are needed
• Load-rated hinges and correctly powered closer
• Frame fixing and structural gap sealing recorded with photos
• Intumescent and smoke seals as specified

Which fire door rules apply in Canterbury?

In Canterbury, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Canterbury building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Who needs FD60 fire doors in Canterbury?

From mixed-use commercial buildings to refuse stores, the requirement for FD60 fire doors in Canterbury comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.

Our process in Canterbury

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Prices for FD60 fire doors in Canterbury

If you need a budget figure first, the guide for FD60 fire doors is £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.

Nearby areas we cover from Canterbury

Nearby towns we cover include Whitstable, Herne Bay and Faversham. Distance from Canterbury does not change our guide prices, and the survey and quote are free.

Questions