Communal fire doors for Canterbury buildings
From the CT1 postcode district outwards, we take on communal fire doors across Canterbury for homes, blocks and workplaces.
Around Canterbury, HMOs, industrial estates and houses with integral garages all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
We phase communal door replacements in Canterbury so every escape route stays protected throughout the programme. The evidence pack for each communal door in Canterbury is set out to support whatever checking regime your fire risk assessment sets.
Pairs, vision panels and robust finishes
We fit single, double and leaf-and-a-half communal doors, with vision panels in tested glazing systems and finishes chosen to stand up to use, such as laminates and kick plates covered by the certification. For pairs, the meeting edges, rebates and any door coordinator must match the evidence; see our double fire doors page.
Each installation includes:
- Closers, coordinators and hold-opens as required
- Evidence pack suitable for regulation 10 records
- Certified single, double or leaf-and-a-half doorsets
- Phased programme keeping escape routes protected
What the rules say for Canterbury
The rules that apply to fire doors in Canterbury are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Canterbury block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Buildings and duty holders in Canterbury
You are most likely to need communal fire doors if you look after student accommodation, hotels or sheltered and supported housing. Whatever the building in Canterbury, we survey each opening and tell you which doors need work and which do not.
The steps on a Canterbury installation
- Survey communal doors and plan a phased sequence
- Agree working hours and resident notices with the client
- Order doorsets to size with matching hardware
- Replace doors one route section at a time
- Commission closers and hold-opens with the alarm contractor
- Hand over evidence for your fire safety records
What does communal fire doors cost in Canterbury?
As a guide, budget from around £800 for a single communal doorset to £3,200 for a glazed pair, ex VAT for communal fire doors. The figure for your Canterbury building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Canterbury and neighbouring towns
Canterbury is about 39.2 km from Maidstone, and we cover both, along with nearby Whitstable and Herne Bay. Send us your postcode and we'll confirm survey dates.
Questions
Do you work in Canterbury?
Yes, we take on communal fire doors in Canterbury and the surrounding area, including Whitstable and Herne Bay. Send your postcode and a few details and we'll come back with survey dates.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
Do communal doors need vision panels?
Not always, but they are common on cross-corridor and lobby doors so people can see who is coming the other way. Any glazing has to be fire-rated and fitted in a tested system.
Will the stairs be out of use while you work?
No. We phase the work so that each route stays protected and usable, replacing doors one section at a time and never leaving an opening without a door at the end of the day.