FD30 fire doors in Leigh, done to the evidence
Looking for FD30 fire doors in Leigh? We supply and fit certified fire doors and components across Leigh and the wider Greater Manchester area, working from a free survey and a fixed written quote.
Leigh has a broad mix of buildings, including family homes after loft conversions, light industrial buildings and care homes, and the same fire door principles apply to all of them.
In Leigh, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. For a mixed portfolio in Leigh, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side.
Where are FD30 doors used?
FD30 is the rating most buildings rely on. You will find it on flat entrance doors, doors onto escape corridors and stairs in houses in multiple occupation, kitchen doors in HMOs, and most internal doors on escape routes in offices, schools, surgeries and shops. Where smoke control matters too, the door is specified as FD30S (E30Sa), which adds a smoke seal and a tighter threshold.
The rating your building needs comes from its fire strategy or fire risk assessment, not from the door supplier. If you are unsure whether a door should be FD30 or FD60, we check the drawings, the risk assessment and what is installed now before we price anything. Our FD30 vs FD60 guide explains the difference.
What you get:
- Fire-tested hinges, latch or lock and intumescent pads
- Overhead closer set to close and latch
- Photo record, product data and certificate references at handover
- Certified FD30 or FD30S leaf, or full doorset
Which fire door rules apply in Leigh?
In Leigh, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Leigh building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Buildings and duty holders in Leigh
From care homes to shops, the requirement for FD30 fire doors in Leigh comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.
From enquiry to handover in Leigh
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Budgeting for FD30 fire doors in Leigh
If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Nearby areas we cover from Leigh
Neighbouring towns such as Atherton, Tyldesley, Golborne and Westhoughton are covered too, so clients with several buildings can use one installer and one evidence format.
Common questions
Is Leigh within your coverage area?
It is. We cover Leigh in Greater Manchester and neighbouring towns such as Atherton. There is no charge for the survey.
Can you work from an existing inspection report for my Leigh building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
What is the difference between FD30 and FD30S?
FD30S has been tested for smoke control as well as fire. It adds a smoke seal, usually a brush or blade, and needs a tight threshold gap. Flat entrance doors and doors onto protected escape routes are commonly specified as FD30S.
Can a new FD30 door go into my old frame?
Sometimes. The frame has to be sound, square, securely fixed and compatible with the new leaf's certification. Many older frames are not, especially softwood linings or frames altered for previous doors. We check each frame on the survey and recommend a doorset only where the frame cannot be relied on.