FD30 fire doors in Oldham

Getting FD30 fire doors right in Oldham

If you need FD30 fire doors in Oldham, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.

Oldham has a broad mix of buildings, including purpose-built blocks of flats, shared houses and hotels, and the same fire door principles apply to all of them.

For a mixed portfolio in Oldham, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side. Each FD30 leaf we supply for Oldham is sized for the opening, rather than trimmed beyond what its certification allows.

Leaf only or a full doorset?

If the existing frame is sound, correctly sized, securely fixed and compatible with the new leaf's certification, a new FD30 leaf can be hung in it. Many frames do not pass that test: old softwood linings, frames that have been cut about for previous doors, or frames with no evidence of how they were fixed. In those cases a certified doorset (leaf, frame and ironmongery tested together) is the cleaner answer and usually the quicker one on site.

We tell you which route each opening needs on the survey, door by door, and why.

Each installation includes:

• Frame-to-wall gap sealed with an evidenced material
• Intumescent strips and smoke seals to the certification
• Photo record, product data and certificate references at handover
• Fire-tested hinges, latch or lock and intumescent pads

The regulations behind fire doors in Oldham

In Oldham, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Oldham building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Who needs FD30 fire doors in Oldham?

From shops to care homes, the requirement for FD30 fire doors in Oldham comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.

What happens after you enquire

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Oldham?

As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Oldham building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Around Oldham

Neighbouring towns such as Chadderton, Royton, Failsworth and Middleton are covered too, so clients with several buildings can use one installer and one evidence format.

Questions from Oldham