Getting FD30 fire doors right in Tyldesley
Our FD30 fire doors service covers Tyldesley and the wider Greater Manchester area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
Fire doors in Tyldesley protect escape routes in care homes, small offices and houses with integral garages alike. We adapt the programme to the building and its occupants, never the standard of the installation.
In Tyldesley, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. For a mixed portfolio in Tyldesley, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side.
Where are FD30 doors used?
FD30 is the rating most buildings rely on. You will find it on flat entrance doors, doors onto escape corridors and stairs in houses in multiple occupation, kitchen doors in HMOs, and most internal doors on escape routes in offices, schools, surgeries and shops. Where smoke control matters too, the door is specified as FD30S (E30Sa), which adds a smoke seal and a tighter threshold.
The rating your building needs comes from its fire strategy or fire risk assessment, not from the door supplier. If you are unsure whether a door should be FD30 or FD60, we check the drawings, the risk assessment and what is installed now before we price anything. Our FD30 vs FD60 guide explains the difference.
On a typical job that means:
- Fire-tested hinges, latch or lock and intumescent pads
- Frame-to-wall gap sealed with an evidenced material
- Certified FD30 or FD30S leaf, or full doorset
- Intumescent strips and smoke seals to the certification
Fire door law for Tyldesley properties
In Tyldesley, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Tyldesley building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Who needs FD30 fire doors in Tyldesley?
You are most likely to need FD30 fire doors if you look after blocks of flats, shops or care homes. Whatever the building in Tyldesley, we survey each opening and tell you which doors need work and which do not.
Our process in Tyldesley
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Guide prices in Tyldesley
As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Tyldesley building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Tyldesley and neighbouring towns
Tyldesley is about 15.7 km from Manchester, and we cover both, along with nearby Atherton and Leigh. Send us your postcode and we'll confirm survey dates.
Questions from Tyldesley
Do you work in Tyldesley?
Yes, we take on FD30 fire doors in Tyldesley and the surrounding area, including Atherton and Leigh. Send your postcode and a few details and we'll come back with survey dates.
Can you work from an existing inspection report for my Tyldesley building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Do FD30 doors need a closer?
Most do. Doors on escape routes, flat entrance doors and doors in the common parts of buildings need a self-closing device that shuts and latches the door. Some doors inside houses and locked riser doors are exceptions, depending on the fire strategy.
How long does it take to fit an FD30 door?
A leaf into a sound frame is often a few hours. A full doorset including frame removal, fixing, sealing and making good is usually half a day to a day per opening, depending on access and the wall construction.