FD30 fire doors in Bloxwich

FD30 fire doors for Bloxwich buildings

If you need FD30 fire doors in Bloxwich, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.

Around Bloxwich, small blocks of flats, family homes after loft conversions and schools all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

Each FD30 leaf we supply for Bloxwich is sized for the opening, rather than trimmed beyond what its certification allows. In Bloxwich, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

What you get:

• Photo record, product data and certificate references at handover
• Certified FD30 or FD30S leaf, or full doorset
• Survey of the opening, frame and existing ironmongery
• Fire-tested hinges, latch or lock and intumescent pads

What the rules say for Bloxwich

Fire doors in Bloxwich fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Bloxwich above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Buildings and duty holders in Bloxwich

The need for FD30 fire doors usually arises in shops or blocks of flats, and sometimes offices. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Bloxwich to keep escape routes protected throughout.

From enquiry to handover in Bloxwich

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Budgeting for FD30 fire doors in Bloxwich

Guide pricing for FD30 fire doors: £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. Volume work across several doors in one Bloxwich building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Bloxwich and neighbouring towns

Neighbouring towns such as Walsall, Willenhall, Wednesfield and Aldridge are covered too, so clients with several buildings can use one installer and one evidence format.

Common questions