FD30 fire doors in Birmingham, done to the evidence
Looking for FD30 fire doors in Birmingham? We supply and fit certified fire doors and components across Birmingham and the wider West Midlands area, working from a free survey and a fixed written quote.
Around Birmingham, mixed-use office buildings, hotels and restaurants all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
In Birmingham, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Birmingham is sized for the opening, rather than trimmed beyond what its certification allows.
What does a correct FD30 installation include?
A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.
Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.
As standard, the work covers:
- Certified FD30 or FD30S leaf, or full doorset
- Overhead closer set to close and latch
- Fire-tested hinges, latch or lock and intumescent pads
- Frame-to-wall gap sealed with an evidenced material
The regulations behind fire doors in Birmingham
In Birmingham, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Birmingham building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Where FD30 fire doors fit in Birmingham
Landlords, managing agents, facilities teams and homeowners in Birmingham can all commission FD30 fire doors from us. The usual settings are blocks of flats and offices, though single doors for care homes are just as welcome.
What happens after you enquire
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Prices for FD30 fire doors in Birmingham
If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Around Birmingham
Beyond Birmingham itself we also cover nearby towns such as Aston (2.3 km), Smethwick and Washwood Heath. The service, pricing and evidence are the same wherever you are.
Questions from Birmingham
Do you work in Birmingham?
Yes, we take on FD30 fire doors in Birmingham and the surrounding area, including Aston and Smethwick. Send your postcode and a few details and we'll come back with survey dates.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
What is the difference between FD30 and FD30S?
FD30S has been tested for smoke control as well as fire. It adds a smoke seal, usually a brush or blade, and needs a tight threshold gap. Flat entrance doors and doors onto protected escape routes are commonly specified as FD30S.
Do FD30 doors need a closer?
Most do. Doors on escape routes, flat entrance doors and doors in the common parts of buildings need a self-closing device that shuts and latches the door. Some doors inside houses and locked riser doors are exceptions, depending on the fire strategy.