FD30 fire doors in Shirley

FD30 fire doors: our service in Shirley

We provide FD30 fire doors in Shirley (B90 and the surrounding postcodes), from the first survey through to a documented handover.

Buildings in and around Shirley range from family homes after loft conversions to light industrial buildings and schools. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

In Shirley, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. For a mixed portfolio in Shirley, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

Each installation includes:

• Fire-tested hinges, latch or lock and intumescent pads
• Certified FD30 or FD30S leaf, or full doorset
• Frame-to-wall gap sealed with an evidenced material
• Photo record, product data and certificate references at handover

Rules and responsibilities in Shirley

In Shirley, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Shirley building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Which buildings in Shirley need FD30 fire doors?

You are most likely to need FD30 fire doors if you look after blocks of flats, shops or care homes. Whatever the building in Shirley, we survey each opening and tell you which doors need work and which do not.

From enquiry to handover in Shirley

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Budgeting for FD30 fire doors in Shirley

If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.

Around Shirley

Neighbouring towns such as Solihull, Acocks Green, Birmingham and Washwood Heath are covered too, so clients with several buildings can use one installer and one evidence format.

Common questions