FD30 fire doors in Wednesbury

FD30 fire doors in Wednesbury: what's involved

When you book FD30 fire doors in Wednesbury, the aim is simple: doors that close, latch and seal as tested, with records that prove it.

Wednesbury has a broad mix of buildings, including small offices, light industrial buildings and houses with integral garages, and the same fire door principles apply to all of them.

For a mixed portfolio in Wednesbury, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side. Each FD30 leaf we supply for Wednesbury is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

On a typical job that means:

• Survey of the opening, frame and existing ironmongery
• Fire-tested hinges, latch or lock and intumescent pads
• Photo record, product data and certificate references at handover
• Frame-to-wall gap sealed with an evidenced material

What the rules say for Wednesbury

In Wednesbury, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Wednesbury building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Who needs FD30 fire doors in Wednesbury?

Typical settings for FD30 fire doors include blocks of flats, schools and HMOs. In Wednesbury, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

How a Wednesbury job runs

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Budgeting for FD30 fire doors in Wednesbury

Budget around £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. Our guide prices are the same in Wednesbury as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.

Around Wednesbury

Neighbouring towns such as Tipton, West Bromwich, Willenhall and Walsall are covered too, so clients with several buildings can use one installer and one evidence format.

Common questions