FD30 fire doors in Garston

FD30 fire doors for Garston buildings

Looking for FD30 fire doors in Garston? We supply and fit certified fire doors and components across Garston and the wider Merseyside area, working from a free survey and a fixed written quote.

Buildings in and around Garston range from care homes to schools and small blocks of flats. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

In Garston, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Garston is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

As standard, the work covers:

• Frame-to-wall gap sealed with an evidenced material
• Certified FD30 or FD30S leaf, or full doorset
• Survey of the opening, frame and existing ironmongery
• Photo record, product data and certificate references at handover

The regulations behind fire doors in Garston

England's framework applies in Garston. Approved Document B guides the fire performance of new and replacement doors under the Building Regulations 2010. Day-to-day duties sit with the responsible person under the Fire Safety Order 2005, and for multi-occupied residential buildings, the Fire Safety (England) Regulations 2022 add duties such as giving residents information about fire doors.

For blocks over 11 metres in Garston, those regulations require communal fire door checks at least every three months and best-endeavours flat entrance door checks each year. In higher-risk buildings, building work is overseen by the Building Safety Regulator, so we check whether approval is needed before starting.

Which buildings in Garston need FD30 fire doors?

Typical settings for FD30 fire doors include shops, offices and schools. In Garston, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

The steps on a Garston installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Garston?

Guide pricing for FD30 fire doors: £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. Volume work across several doors in one Garston building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Garston and neighbouring towns

Garston is about 10.0 km from Liverpool, and we cover both, along with nearby Speke and Halewood. Send us your postcode and we'll confirm survey dates.

Common questions