FD30 fire doors in Stratford

FD30 fire doors in Stratford: what's involved

We provide FD30 fire doors in Stratford (E15 and the surrounding postcodes), from the first survey through to a documented handover.

Stratford has a broad mix of buildings, including clinics, student accommodation and hotels, and the same fire door principles apply to all of them.

Each FD30 leaf we supply for Stratford is sized for the opening, rather than trimmed beyond what its certification allows. In Stratford, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

Each installation includes:

• Photo record, product data and certificate references at handover
• Frame-to-wall gap sealed with an evidenced material
• Fire-tested hinges, latch or lock and intumescent pads
• Overhead closer set to close and latch

Fire door law for Stratford properties

The rules that apply to fire doors in Stratford are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts. Enforcement of fire safety law in Stratford sits with the London Fire Brigade.

Where a Stratford block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.

Buildings and duty holders in Stratford

The need for FD30 fire doors usually arises in schools or HMOs, and sometimes blocks of flats. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Stratford to keep escape routes protected throughout.

From enquiry to handover in Stratford

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Stratford?

Budget around £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. Our guide prices are the same in Stratford as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.

Nearby areas we cover from Stratford

Neighbouring towns such as Bow, Canning Town, Canary Wharf and Leytonstone are covered too, so clients with several buildings can use one installer and one evidence format.

Common questions