FD30 fire doors in Richmond

What FD30 fire doors in Richmond should include

If you need FD30 fire doors in Richmond, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.

In and around Richmond, fire door work covers everything from shared houses to purpose-built blocks of flats. We plan each job around the people who use the building.

For a mixed portfolio in Richmond, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side. Each FD30 leaf we supply for Richmond is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

On a typical job that means:

• Survey of the opening, frame and existing ironmongery
• Photo record, product data and certificate references at handover
• Overhead closer set to close and latch
• Certified FD30 or FD30S leaf, or full doorset

Which fire door rules apply in Richmond?

In Richmond, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet. In London, the London Fire Brigade is the enforcing authority for fire safety law.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Richmond building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Where FD30 fire doors fit in Richmond

The need for FD30 fire doors usually arises in schools or shops, and sometimes blocks of flats. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Richmond to keep escape routes protected throughout.

What happens after you enquire

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Richmond

Budget around £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. Our guide prices are the same in Richmond as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.

Richmond and neighbouring towns

Neighbouring towns such as Isleworth, Hounslow, Barnes and Chiswick are covered too, so clients with several buildings can use one installer and one evidence format.

Questions