FD60 fire doors: our service in Seaford
For property owners, landlords and managing agents in Seaford, we offer FD60 fire doors with one team for the survey, the product and the installation.
Fire doors in Seaford protect escape routes in family homes after loft conversions, houses with integral garages and small blocks of flats alike. We adapt the programme to the building and its occupants, never the standard of the installation.
Before ordering FD60 doors for a Seaford building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Seaford we generally fit certified doorsets, so frame and leaf share the same test evidence.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
Each installation includes:
- Intumescent and smoke seals as specified
- Load-rated hinges and correctly powered closer
- Check of the fire strategy rating for each opening
- 60-minute glazing systems where vision panels are needed
The regulations behind fire doors in Seaford
The rules that apply to fire doors in Seaford are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Seaford block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where FD60 fire doors fit in Seaford
You are most likely to need FD60 fire doors if you look after refuse stores, stair cores in taller blocks or mixed-use commercial buildings. Whatever the building in Seaford, we survey each opening and tell you which doors need work and which do not.
How a Seaford job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Prices for FD60 fire doors in Seaford
Guide pricing for FD60 fire doors: £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. Volume work across several doors in one Seaford building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Around Seaford
Neighbouring towns such as Rottingdean, Eastbourne, Hailsham and Brighton are covered too, so clients with several buildings can use one installer and one evidence format.
Common questions
Do you cover BN25 and nearby postcodes?
Yes. We cover Seaford including BN25, and nearby towns such as Rottingdean and Eastbourne. The survey and written quote are free.
What happens on a survey in Seaford?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.
Are FD60 doors harder to open?
They are heavier, so the closer has to be chosen and adjusted with care. A well-set closer will still close and latch the door while keeping the opening force reasonable for the people who use it.