FD30 fire doors in Plymouth

What FD30 fire doors in Plymouth should include

Our FD30 fire doors service covers Plymouth and the wider Devon area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Plymouth has a broad mix of buildings, including restaurants, shared houses and student accommodation, and the same fire door principles apply to all of them.

In Plymouth, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. For a mixed portfolio in Plymouth, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

What you get:

• Photo record, product data and certificate references at handover
• Frame-to-wall gap sealed with an evidenced material
• Certified FD30 or FD30S leaf, or full doorset
• Overhead closer set to close and latch

Which fire door rules apply in Plymouth?

In Plymouth, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Plymouth building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Where FD30 fire doors fit in Plymouth

You are most likely to need FD30 fire doors if you look after offices, shops or schools. Whatever the building in Plymouth, we survey each opening and tell you which doors need work and which do not.

The steps on a Plymouth installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Plymouth

Guide pricing for FD30 fire doors: £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. Volume work across several doors in one Plymouth building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Covering Plymouth and nearby

Beyond Plymouth itself we also cover nearby towns such as Plymstock (3.9 km), Paignton and Newton Abbot. The service, pricing and evidence are the same wherever you are.

Questions