FD30 fire doors in Heavitree

FD30 fire doors in Heavitree, done to the evidence

Our FD30 fire doors service covers Heavitree and the wider Devon area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Buildings in and around Heavitree range from care homes to small offices and family homes after loft conversions. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

In Heavitree, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Heavitree is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

What you get:

• Frame-to-wall gap sealed with an evidenced material
• Fire-tested hinges, latch or lock and intumescent pads
• Survey of the opening, frame and existing ironmongery
• Intumescent strips and smoke seals to the certification

Rules and responsibilities in Heavitree

Fire doors in Heavitree fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Heavitree above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Who needs FD30 fire doors in Heavitree?

The need for FD30 fire doors usually arises in shops or care homes, and sometimes offices. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Heavitree to keep escape routes protected throughout.

The steps on a Heavitree installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Heavitree

As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Heavitree building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Around Heavitree

We also cover towns near Heavitree, including Exeter (2.2 km away), Exmouth and Tiverton. If your building is in EX1 or a neighbouring district, the service and pricing are the same.

Common questions