FD60 fire door installation in Walton-on-Thames

FD60 fire doors in Walton-on-Thames, done to the evidence

Our FD60 fire doors service covers Walton-on-Thames and the wider Surrey area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Buildings in and around Walton-on-Thames range from family homes after loft conversions to houses with integral garages and small offices. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

For FD60 work in Walton-on-Thames we generally fit certified doorsets, so frame and leaf share the same test evidence. FD60 openings in Walton-on-Thames buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.

When does a building need FD60 rather than FD30?

FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.

We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.

Each installation includes:

• Intumescent and smoke seals as specified
• Certified FD60 doorset or leaf with matching evidence
• Frame fixing and structural gap sealing recorded with photos
• Check of the fire strategy rating for each opening

Which fire door rules apply in Walton-on-Thames?

In Walton-on-Thames, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Walton-on-Thames building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Which buildings in Walton-on-Thames need FD60 fire doors?

You are most likely to need FD60 fire doors if you look after refuse stores, stair cores in taller blocks or plant and boiler rooms. Whatever the building in Walton-on-Thames, we survey each opening and tell you which doors need work and which do not.

Our process in Walton-on-Thames

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Budgeting for FD60 fire doors in Walton-on-Thames

As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Walton-on-Thames building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Around Walton-on-Thames

Walton-on-Thames is about 12.6 km from Woking, and we cover both, along with nearby Sunbury-on-Thames and Esher. Send us your postcode and we'll confirm survey dates.

Questions