FD60 fire doors for Tamworth buildings
For property owners, landlords and managing agents in Tamworth, we offer FD60 fire doors with one team for the survey, the product and the installation.
In and around Tamworth, fire door work covers everything from high-street shops to low-rise blocks of flats. We plan each job around the people who use the building.
Before ordering FD60 doors for a Tamworth building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Tamworth we generally fit certified doorsets, so frame and leaf share the same test evidence.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
On a typical job that means:
- Intumescent and smoke seals as specified
- Frame fixing and structural gap sealing recorded with photos
- 60-minute glazing systems where vision panels are needed
- Certified FD60 doorset or leaf with matching evidence
Fire door law for Tamworth properties
In Tamworth, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Tamworth building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Buildings and duty holders in Tamworth
The need for FD60 fire doors usually arises in plant and boiler rooms or mixed-use commercial buildings, and sometimes refuse stores. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Tamworth to keep escape routes protected throughout.
How a Tamworth job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Prices for FD60 fire doors in Tamworth
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Tamworth building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Covering Tamworth and nearby
Tamworth is about 52.7 km from Stoke-on-Trent, and we cover both, along with nearby Lichfield and Sutton Coldfield. Send us your postcode and we'll confirm survey dates.
Questions
Is Tamworth within your coverage area?
It is. We cover Tamworth in Staffordshire and neighbouring towns such as Lichfield. There is no charge for the survey.
What happens on a survey in Tamworth?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.
Are FD60 doors harder to open?
They are heavier, so the closer has to be chosen and adjusted with care. A well-set closer will still close and latch the door while keeping the opening force reasonable for the people who use it.