FD60 fire doors: our service in Burntwood
Our FD60 fire doors service covers Burntwood and the wider Staffordshire area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
Burntwood has a broad mix of buildings, including small offices, houses with integral garages and schools, and the same fire door principles apply to all of them.
Before ordering FD60 doors for a Burntwood building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Burntwood we generally fit certified doorsets, so frame and leaf share the same test evidence.
Why FD60 installation is less forgiving
A 54mm leaf can weigh considerably more than a 44mm one. That weight drives everything else: more robust frames and fixings, hinges rated for the load, and a closer with enough power to close and latch the door without making it too heavy to open. Glazing, if any, must use a 60-minute glass and glazing system from the same test evidence.
Because of this, most FD60 openings are best done as a certified doorset, so the frame and leaf come with matching evidence.
Each installation includes:
- Certified FD60 doorset or leaf with matching evidence
- Frame fixing and structural gap sealing recorded with photos
- Load-rated hinges and correctly powered closer
- Intumescent and smoke seals as specified
Rules and responsibilities in Burntwood
Fire doors in Burntwood fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Burntwood above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Where FD60 fire doors fit in Burntwood
Landlords, managing agents, facilities teams and homeowners in Burntwood can all commission FD60 fire doors from us. The usual settings are mixed-use commercial buildings and refuse stores, though single doors for plant and boiler rooms are just as welcome.
What happens after you enquire
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
What does FD60 fire doors cost in Burntwood?
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Burntwood building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Burntwood
Nearby towns we cover include Lichfield, Cannock and Aldridge. Distance from Burntwood does not change our guide prices, and the survey and quote are free.
Questions from Burntwood
Do you cover WS7 and nearby postcodes?
Yes. We cover Burntwood including WS7, and nearby towns such as Lichfield and Cannock. The survey and written quote are free.
Can you work from an existing inspection report for my Burntwood building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.
Are FD60 doors harder to open?
They are heavier, so the closer has to be chosen and adjusted with care. A well-set closer will still close and latch the door while keeping the opening force reasonable for the people who use it.