FD60 fire doors for Bexley buildings
When you book FD60 fire doors in Bexley, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
In and around Bexley, fire door work covers everything from care homes to schools. We plan each job around the people who use the building.
Before ordering FD60 doors for a Bexley building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Bexley we generally fit certified doorsets, so frame and leaf share the same test evidence.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
As standard, the work covers:
- Load-rated hinges and correctly powered closer
- Certified FD60 doorset or leaf with matching evidence
- 60-minute glazing systems where vision panels are needed
- Intumescent and smoke seals as specified
The regulations behind fire doors in Bexley
The rules that apply to fire doors in Bexley are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts. In London, the London Fire Brigade is the enforcing authority for fire safety law.
Where a Bexley block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Buildings and duty holders in Bexley
From mixed-use commercial buildings to refuse stores, the requirement for FD60 fire doors in Bexley comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.
How a Bexley job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Prices for FD60 fire doors in Bexley
If you need a budget figure first, the guide for FD60 fire doors is £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Covering Bexley and nearby
We also cover towns near Bexley, including Welling (3.7 km away), Dartford and Swanley. If your building is in DA5 or a neighbouring district, the service and pricing are the same.
Questions
Is Bexley within your coverage area?
It is. We cover Bexley in Greater London and neighbouring towns such as Welling. There is no charge for the survey.
What happens on a survey in Bexley?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.