FD30 fire doors in Ashford (Kent)

FD30 fire doors for Ashford (Kent) buildings

Our FD30 fire doors service covers Ashford (Kent) and the wider Kent area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Fire doors in Ashford (Kent) protect escape routes in industrial estates, care homes and family homes after loft conversions alike. We adapt the programme to the building and its occupants, never the standard of the installation.

In Ashford (Kent), FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Ashford (Kent) is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

What you get:

• Survey of the opening, frame and existing ironmongery
• Overhead closer set to close and latch
• Frame-to-wall gap sealed with an evidenced material
• Certified FD30 or FD30S leaf, or full doorset

Rules and responsibilities in Ashford (Kent)

England's framework applies in Ashford (Kent). Approved Document B guides the fire performance of new and replacement doors under the Building Regulations 2010. Day-to-day duties sit with the responsible person under the Fire Safety Order 2005, and for multi-occupied residential buildings, the Fire Safety (England) Regulations 2022 add duties such as giving residents information about fire doors.

For blocks over 11 metres in Ashford (Kent), those regulations require communal fire door checks at least every three months and best-endeavours flat entrance door checks each year. In higher-risk buildings, building work is overseen by the Building Safety Regulator, so we check whether approval is needed before starting.

Buildings and duty holders in Ashford (Kent)

Typical settings for FD30 fire doors include shops, blocks of flats and care homes. In Ashford (Kent), as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

The steps on a Ashford (Kent) installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Guide prices in Ashford (Kent)

Guide pricing for FD30 fire doors: £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. Volume work across several doors in one Ashford (Kent) building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Nearby areas we cover from Ashford (Kent)

Neighbouring towns such as Faversham, Canterbury, Folkestone and Sittingbourne are covered too, so clients with several buildings can use one installer and one evidence format.

Questions