Riser and cupboard fire doors: our service in Eastleigh
When you book riser and cupboard fire doors in Eastleigh, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
Eastleigh has a broad mix of buildings, including family homes after loft conversions, schools and high-street shops, and the same fire door principles apply to all of them.
While fitting riser doors in Eastleigh, we photograph any gaps in fire stopping we can see and pass them on to you. Riser and meter cupboard doors in Eastleigh blocks are easy to overlook until an inspection flags them.
The fire stopping behind the door
The door is only half the picture. Inside the riser, the services passing through each floor must be fire stopped. That is a separate specialist task. Where we find gaps or missing fire stopping while fitting riser doors, we record it and flag it to you so it can be addressed.
On a typical job that means:
- Locks and keep-locked arrangements as specified
- Fire-rated riser and cupboard doorsets
- Single and double flush configurations
- Signage as required
Rules and responsibilities in Eastleigh
In Eastleigh, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Eastleigh building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Which buildings in Eastleigh need riser and cupboard fire doors?
The need for riser and cupboard fire doors usually arises in hotels or blocks of flats, and sometimes student accommodation. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Eastleigh to keep escape routes protected throughout.
The steps on a Eastleigh installation
- Survey risers, cupboards and wall ratings
- Confirm locked-shut or self-closing for each door
- Order doorsets sized to the openings
- Install and seal frames, hang leaves
- Fit locks, seals and signage
- Photograph and report on visible fire stopping
Prices for riser and cupboard fire doors in Eastleigh
If you need a budget figure first, the guide for riser and cupboard fire doors is £450–£1,200 per riser or cupboard doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Nearby areas we cover from Eastleigh
Neighbouring towns such as Southampton, Winchester, Totton and Hythe are covered too, so clients with several buildings can use one installer and one evidence format.
Questions
Do you cover SO50 and nearby postcodes?
Yes. We cover Eastleigh including SO50, and nearby towns such as Southampton and Winchester. The survey and written quote are free.
Can you work from an existing inspection report for my Eastleigh building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Do riser doors need closers?
Not if they are kept locked shut and the fire strategy allows it; they should then be labelled accordingly. Cupboards that are opened regularly normally need self-closers.
What rating should a riser door be?
It should match the fire resistance the strategy requires for the riser enclosure, commonly 30 or 60 minutes. We confirm it before ordering.