Fire door hold-open devices: our service in Ashton-in-Makerfield
If you need fire door hold-open devices in Ashton-in-Makerfield, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.
Around Ashton-in-Makerfield, schools, small offices and houses with integral garages all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
We coordinate with your fire alarm contractor in Ashton-in-Makerfield so every hold-open releases when it should. Free-swing closers suit Ashton-in-Makerfield settings where residents or pupils find doors hard to open.
Why doors get wedged
Busy corridors, care homes and schools have doors that people need open all day. If there is no safe way to hold them, they get wedged, which defeats the door completely. A hold-open device or free-swing closer solves the problem properly.
As standard, the work covers:
- Release testing with the alarm
- Record of devices and test results
- Hold-open and free-swing closers
- Coordination of alarm interface
Fire door law for Ashton-in-Makerfield properties
The rules that apply to fire doors in Ashton-in-Makerfield are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Ashton-in-Makerfield block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where fire door hold-open devices fit in Ashton-in-Makerfield
You are most likely to need fire door hold-open devices if you look after clinics, communal corridors or offices. Whatever the building in Ashton-in-Makerfield, we survey each opening and tell you which doors need work and which do not.
How a Ashton-in-Makerfield job runs
- Survey the doors and the fire alarm arrangement
- Choose device type for each door
- Agree interface work with the alarm contractor
- Fit and commission the devices
- Test release on alarm activation
- Record results and hand over
Guide prices in Ashton-in-Makerfield
As a guide, budget £180–£450 per door for the device, excluding fire alarm interface work, ex VAT for fire door hold-open devices. The figure for your Ashton-in-Makerfield building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Ashton-in-Makerfield
Neighbouring towns such as Golborne, Newton-le-Willows, St Helens and Wigan are covered too, so clients with several buildings can use one installer and one evidence format.
Questions
Is Ashton-in-Makerfield within your coverage area?
It is. We cover Ashton-in-Makerfield in Greater Manchester and neighbouring towns such as Golborne. There is no charge for the survey.
Can you work from an existing inspection report for my Ashton-in-Makerfield building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Who tests hold-open devices?
They should be tested with the fire alarm as part of the routine testing arrangements. We test them at installation and record the results.
Do hold-open devices need the fire alarm?
Hard-wired devices are released by the fire alarm system. Some battery units detect the alarm sound instead; they must be suitable for the building and its alarm.