Fire door hold-open devices: our service in Salford
We provide fire door hold-open devices in Salford (M6 and the surrounding postcodes), from the first survey through to a documented handover.
Fire doors in Salford protect escape routes in GP surgeries, purpose-built flats and schools alike. We adapt the programme to the building and its occupants, never the standard of the installation.
We coordinate with your fire alarm contractor in Salford so every hold-open releases when it should. Free-swing closers suit Salford settings where residents or pupils find doors hard to open.
Types of hold-open
Electromagnetic door holders are wall or floor magnets wired to the fire alarm. Hold-open closers combine the closer and the hold-open in one unit. Free-swing closers let the door move freely and close it on alarm. Some battery units listen for the alarm sound; these must be suitable for the alarm system and the building. The right choice depends on the door, the alarm and how people use the space.
Each installation includes:
- Assessment of door use and alarm system
- Electromagnetic holders to BS EN 1155
- Release testing with the alarm
- Coordination of alarm interface
Fire door law for Salford properties
In Salford, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Salford building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Who needs fire door hold-open devices in Salford?
The need for fire door hold-open devices usually arises in care homes or offices, and sometimes clinics. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Salford to keep escape routes protected throughout.
From enquiry to handover in Salford
- Survey the doors and the fire alarm arrangement
- Choose device type for each door
- Agree interface work with the alarm contractor
- Fit and commission the devices
- Test release on alarm activation
- Record results and hand over
What does fire door hold-open devices cost in Salford?
As a guide, budget £180–£450 per door for the device, excluding fire alarm interface work, ex VAT for fire door hold-open devices. The figure for your Salford building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Covering Salford and nearby
Neighbouring towns such as Eccles, Old Trafford, Manchester and Swinton are covered too, so clients with several buildings can use one installer and one evidence format.
Questions
Is Salford within your coverage area?
It is. We cover Salford in Greater Manchester and neighbouring towns such as Eccles. There is no charge for the survey.
Can you work from an existing inspection report for my Salford building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Who tests hold-open devices?
They should be tested with the fire alarm as part of the routine testing arrangements. We test them at installation and record the results.
Do hold-open devices need the fire alarm?
Hard-wired devices are released by the fire alarm system. Some battery units detect the alarm sound instead; they must be suitable for the building and its alarm.