Fire door ironmongery in Leatherhead: what's involved
From the KT22 postcode district outwards, we take on fire door ironmongery across Leatherhead for homes, blocks and workplaces.
Around Leatherhead, light industrial buildings, care homes and houses with integral garages all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Leatherhead we replace them with hardware covered by each door's evidence. Signage for fire doors in Leatherhead buildings is fitted as part of the job, not as an afterthought.
Common hardware defects
Inspections regularly find missing hinge screws, mismatched hinges, plastic-bodied latches, unapproved bolts and locks fitted without intumescent protection. We replace them with items covered by the door's evidence and fit the matching pads and linings.
On a typical job that means:
- Fire-rated hinges, commonly grade 13
- Locks and latches covered by the evidence
- Intumescent pads and lock linings
- Lever handles, pull handles and push plates
What the rules say for Leatherhead
The rules that apply to fire doors in Leatherhead are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Leatherhead block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where fire door ironmongery fit in Leatherhead
Typical settings for fire door ironmongery include hotels, HMOs and blocks of flats. In Leatherhead, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.
The steps on a Leatherhead installation
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Budgeting for fire door ironmongery in Leatherhead
If you need a budget figure first, the guide for fire door ironmongery is from £40 for minor items to £350 for a full hardware set per door, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Covering Leatherhead and nearby
We also cover towns near Leatherhead, including Epsom (5.8 km away), Ewell and Esher. If your building is in KT22 or a neighbouring district, the service and pricing are the same.
Questions
Is Leatherhead within your coverage area?
It is. We cover Leatherhead in Surrey and neighbouring towns such as Epsom. There is no charge for the survey.
How quickly can you survey in Leatherhead?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
Are brass hinges acceptable on fire doors?
Only if they are fire tested and covered by the door's evidence. Many decorative hinges are not.
Do fire doors need signs?
Most fire doors in non-domestic buildings and common parts should carry signage showing whether they are to be kept shut, kept locked or are automatic.