Getting fire door ironmongery right in Herne Bay
When you book fire door ironmongery in Herne Bay, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
Around Herne Bay, small offices, care homes and houses with integral garages all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Herne Bay we replace them with hardware covered by each door's evidence. Signage for fire doors in Herne Bay buildings is fitted as part of the job, not as an afterthought.
Common hardware defects
Inspections regularly find missing hinge screws, mismatched hinges, plastic-bodied latches, unapproved bolts and locks fitted without intumescent protection. We replace them with items covered by the door's evidence and fit the matching pads and linings.
On a typical job that means:
- Locks and latches covered by the evidence
- Intumescent pads and lock linings
- Fire door signage
- Fire-rated hinges, commonly grade 13
Which fire door rules apply in Herne Bay?
In Herne Bay, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Herne Bay building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Where fire door ironmongery fit in Herne Bay
The need for fire door ironmongery usually arises in offices or HMOs, and sometimes blocks of flats. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Herne Bay to keep escape routes protected throughout.
From enquiry to handover in Herne Bay
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Prices for fire door ironmongery in Herne Bay
Budget around from £40 for minor items to £350 for a full hardware set per door, ex VAT for fire door ironmongery. Our guide prices are the same in Herne Bay as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.
Herne Bay and neighbouring towns
We also cover towns near Herne Bay, including Whitstable (7.3 km away), Canterbury and Faversham. If your building is in CT6 or a neighbouring district, the service and pricing are the same.
Common questions
Do you cover CT6 and nearby postcodes?
Yes. We cover Herne Bay including CT6, and nearby towns such as Whitstable and Canterbury. The survey and written quote are free.
How quickly can you survey in Herne Bay?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
Are brass hinges acceptable on fire doors?
Only if they are fire tested and covered by the door's evidence. Many decorative hinges are not.
Can I fit a new lock to a fire door?
Only one that is covered by the door's test evidence, fitted with the correct intumescent protection. A larger lock body or new holes can compromise the door.