Fire door ironmongery: our service in Strood
If you need fire door ironmongery in Strood, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.
Strood has a broad mix of buildings, including schools, light industrial buildings and houses with integral garages, and the same fire door principles apply to all of them.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Strood we replace them with hardware covered by each door's evidence. Signage for fire doors in Strood buildings is fitted as part of the job, not as an afterthought.
Why hardware choice matters
Fire doors are tested with particular hardware. Hinges hold the door in place as it heats up; locks and latches keep it shut against fire pressure; their holes are protected with intumescent linings. Swapping in a cheaper hinge, a larger lock body or a lever on a spindle that melts can change how the door behaves. Hinges for fire doors are commonly grade 13 to BS EN 1935.
Each installation includes:
- Locks and latches covered by the evidence
- Bolts and selectors where specified
- Fire-rated hinges, commonly grade 13
- Lever handles, pull handles and push plates
Rules and responsibilities in Strood
The rules that apply to fire doors in Strood are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Strood block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where fire door ironmongery fit in Strood
Typical settings for fire door ironmongery include blocks of flats, HMOs and schools. In Strood, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.
How a Strood job runs
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Budgeting for fire door ironmongery in Strood
If you need a budget figure first, the guide for fire door ironmongery is from £40 for minor items to £350 for a full hardware set per door, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Nearby areas we cover from Strood
We also cover towns near Strood, including Rochester (2.1 km away), Chatham and Gillingham. If your building is in ME2 or a neighbouring district, the service and pricing are the same.
Questions from Strood
Do you cover ME2 and nearby postcodes?
Yes. We cover Strood including ME2, and nearby towns such as Rochester and Chatham. The survey and written quote are free.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
How many hinges does a fire door need?
Usually at least three, of the type and grade specified in the door's evidence. Heavier or taller doors may need more.
Do fire doors need signs?
Most fire doors in non-domestic buildings and common parts should carry signage showing whether they are to be kept shut, kept locked or are automatic.