Getting FD60 fire doors right in Hertfordshire
Across Hertfordshire, from Watford to Hemel Hempstead, we survey, supply and fit FD60 fire doors for homes, blocks of flats and workplaces.
Before ordering FD60 doors for a Hertfordshire building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. FD60 openings in Hertfordshire buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.
Fire door work in Hertfordshire spans housing providers with large estates, individual landlords, businesses and homeowners. We price every job from a survey, never from a list price alone, because the condition of the frames and the hardware makes a real difference.
When does a building need FD60 rather than FD30?
FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.
We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.
Which fire door rules apply in Hertfordshire?
In Hertfordshire, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Hertfordshire building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
How a Hertfordshire job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Budgeting for FD60 fire doors in Hertfordshire
Budget around £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. Our guide prices are the same in Hertfordshire as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.
Common questions
Do you provide FD60 fire doors across Hertfordshire?
Yes. We cover all of Hertfordshire, including Watford and Hemel Hempstead. Surveys and written quotes are free.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.