FD30 fire doors in Mansfield

FD30 fire doors in Mansfield: what's involved

Our FD30 fire doors service covers Mansfield and the wider Nottinghamshire area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.

Around Mansfield, purpose-built flats, care homes and GP surgeries all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

Each FD30 leaf we supply for Mansfield is sized for the opening, rather than trimmed beyond what its certification allows. In Mansfield, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

Each installation includes:

• Certified FD30 or FD30S leaf, or full doorset
• Intumescent strips and smoke seals to the certification
• Photo record, product data and certificate references at handover
• Overhead closer set to close and latch

Fire door law for Mansfield properties

Fire doors in Mansfield fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Mansfield above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Buildings and duty holders in Mansfield

You are most likely to need FD30 fire doors if you look after schools, care homes or shops. Whatever the building in Mansfield, we survey each opening and tell you which doors need work and which do not.

What happens after you enquire

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Mansfield

Budget around £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. Our guide prices are the same in Mansfield as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.

Covering Mansfield and nearby

We also cover towns near Mansfield, including Sutton in Ashfield (4.2 km away), Kirkby in Ashfield and Hucknall. If your building is in NG18 or a neighbouring district, the service and pricing are the same.

Common questions