FD30 fire doors in Sandhurst: what's involved
From the GU47 postcode district outwards, we take on FD30 fire doors across Sandhurst for homes, blocks and workplaces.
Sandhurst has a broad mix of buildings, including houses with integral garages, schools and light industrial buildings, and the same fire door principles apply to all of them.
In Sandhurst, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Sandhurst is sized for the opening, rather than trimmed beyond what its certification allows.
What does a correct FD30 installation include?
A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.
Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.
On a typical job that means:
- Survey of the opening, frame and existing ironmongery
- Intumescent strips and smoke seals to the certification
- Overhead closer set to close and latch
- Frame-to-wall gap sealed with an evidenced material
Which fire door rules apply in Sandhurst?
Fire doors in Sandhurst fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Sandhurst above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Where FD30 fire doors fit in Sandhurst
Landlords, managing agents, facilities teams and homeowners in Sandhurst can all commission FD30 fire doors from us. The usual settings are schools and blocks of flats, though single doors for offices are just as welcome.
The steps on a Sandhurst installation
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Guide prices in Sandhurst
If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Covering Sandhurst and nearby
We also cover towns near Sandhurst, including Crowthorne (2.6 km away), Yateley and Camberley. If your building is in GU47 or a neighbouring district, the service and pricing are the same.
Common questions
Do you cover GU47 and nearby postcodes?
Yes. We cover Sandhurst including GU47, and nearby towns such as Crowthorne and Yateley. The survey and written quote are free.
What happens on a survey in Sandhurst?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Can a new FD30 door go into my old frame?
Sometimes. The frame has to be sound, square, securely fixed and compatible with the new leaf's certification. Many older frames are not, especially softwood linings or frames altered for previous doors. We check each frame on the survey and recommend a doorset only where the frame cannot be relied on.
Do FD30 doors need a closer?
Most do. Doors on escape routes, flat entrance doors and doors in the common parts of buildings need a self-closing device that shuts and latches the door. Some doors inside houses and locked riser doors are exceptions, depending on the fire strategy.