FD30 fire doors in Crowthorne

Getting FD30 fire doors right in Crowthorne

We provide FD30 fire doors in Crowthorne (RG45 and the surrounding postcodes), from the first survey through to a documented handover.

Around Crowthorne, small offices, family homes after loft conversions and small blocks of flats all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

Each FD30 leaf we supply for Crowthorne is sized for the opening, rather than trimmed beyond what its certification allows. In Crowthorne, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

On a typical job that means:

• Survey of the opening, frame and existing ironmongery
• Intumescent strips and smoke seals to the certification
• Fire-tested hinges, latch or lock and intumescent pads
• Photo record, product data and certificate references at handover

Fire door law for Crowthorne properties

Fire doors in Crowthorne fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Crowthorne above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Where FD30 fire doors fit in Crowthorne

From HMOs to offices, the requirement for FD30 fire doors in Crowthorne comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.

The steps on a Crowthorne installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Crowthorne

As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Crowthorne building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Around Crowthorne

We also cover towns near Crowthorne, including Sandhurst (2.6 km away), Yateley and Camberley. If your building is in RG45 or a neighbouring district, the service and pricing are the same.

Questions from Crowthorne