Intumescent strips and smoke seals in Whitefield, done to the evidence
We provide intumescent strips and smoke seals in Whitefield (M45 and the surrounding postcodes), from the first survey through to a documented handover.
Around Whitefield, small offices, care homes and light industrial buildings all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Painted and missing seals are among the most common fire door defects nationally; in Whitefield we replace them with the type and size the certification specifies. Seal replacement in Whitefield can be combined with any other remedials on the same inspection report.
Why seals fail
Seals are the most common defect on fire door inspections. They get painted over, pulled out, damaged by cleaning or simply worn by years of use. A painted brush seal no longer seals, and a strip of the wrong size may not close the gap in a fire. Our guide to seals explains the different types.
What you get:
- Intumescent strips in frame or leaf edge
- Identification of the specified seals
- Check of gaps and closing after fitting
- Removal of damaged or painted seals
Rules and responsibilities in Whitefield
In Whitefield, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Whitefield building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Who needs intumescent strips and smoke seals in Whitefield?
Landlords, managing agents, facilities teams and homeowners in Whitefield can all commission intumescent strips and smoke seals from us. The usual settings are offices and blocks of flats, though single doors for schools are just as welcome.
How a Whitefield job runs
- Identify door certification and seal specification
- Remove failed seals and clean the grooves
- Fit new strips and seals to the specified positions
- Fit missing pads and lock linings
- Check the door closes and latches against the new seals
- Record the products fitted
Budgeting for intumescent strips and smoke seals in Whitefield
Guide pricing for intumescent strips and smoke seals: £45–£110 per door to supply and fit strips and seals, ex VAT. Volume work across several doors in one Whitefield building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Around Whitefield
Whitefield is about 8.7 km from Manchester, and we cover both, along with nearby Radcliffe and Prestwich. Send us your postcode and we'll confirm survey dates.
Common questions
Do you work in Whitefield?
Yes, we take on intumescent strips and smoke seals in Whitefield and the surrounding area, including Radcliffe and Prestwich. Send your postcode and a few details and we'll come back with survey dates.
How quickly can you survey in Whitefield?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
Can I just add intumescent strips to an ordinary door?
No. Strips do not turn an ordinary door into a fire door. They only work as part of a door that was tested and certified with them.
Can smoke seals be painted?
No. Paint stops brush and blade seals working. If seals have been painted, they should be replaced.