What certified fire doorsets in Winchester should include
Our certified fire doorsets service covers Winchester and the wider Hampshire area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
In and around Winchester, fire door work covers everything from light industrial buildings to small blocks of flats. We plan each job around the people who use the building.
Doorsets suit refurbishment programmes in Winchester, where several openings can be measured, ordered and fitted in one planned sequence. Every doorset we fit in Winchester is handed over with its certificate reference and photographs of the frame fixing and gap sealing.
How is a doorset installed?
The opening is prepared to the size and tolerances in the manufacturer's instructions. The frame is fixed with the specified fixings at the specified centres, packed where needed, and checked for square, plumb and twist. The gap between frame and wall is then sealed with a material covered by the evidence, which BS 8214:2026 now describes in more detail. Finally the leaf is adjusted, the closer is set and the assembly is tested before the architraves go on.
Each installation includes:
- Doorset selection to rating, size and use
- Installation to the manufacturer's instructions
- Closer set-up and close-and-latch testing
- Pre-hung, pre-machined doorsets where available
What the rules say for Winchester
The rules that apply to fire doors in Winchester are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Winchester block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Buildings and duty holders in Winchester
The need for certified fire doorsets usually arises in schools and offices or refurbishment programmes, and sometimes blocks of flats. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Winchester to keep escape routes protected throughout.
How a Winchester job runs
- Survey and measure every structural opening
- Specify doorsets by rating, size, hand, finish and hardware
- Prepare openings and remove existing doors and linings
- Fix and seal the frames to the structure
- Hang, adjust and test each leaf and closer
- Fit architraves, make good and hand over evidence
Guide prices in Winchester
Guide pricing for certified fire doorsets: £650–£1,300 for an FD30 doorset and £850–£1,800 for FD60, supplied and fitted, ex VAT. Volume work across several doors in one Winchester building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Covering Winchester and nearby
Winchester is about 18.9 km from Southampton, and we cover both, along with nearby Eastleigh and Totton. Send us your postcode and we'll confirm survey dates.
Common questions
Is Winchester within your coverage area?
It is. We cover Winchester in Hampshire and neighbouring towns such as Eastleigh. There is no charge for the survey.
How quickly can you survey in Winchester?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
How long do doorsets take to arrive?
Lead times depend on the manufacturer, size, finish and ironmongery. Standard sizes can be quick; bespoke sizes and finishes take longer. We give you the lead time with the quote and confirm it at order.
Do doorsets come painted?
They can be supplied primed, factory painted, veneered, laminated or with a composite skin, depending on the product. Factory finishes avoid painting over seals and labels on site.