Fire door ironmongery in Swinton: what's involved
Our fire door ironmongery service covers Swinton and the wider Greater Manchester area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
Around Swinton, houses with integral garages, light industrial buildings and small blocks of flats all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Signage for fire doors in Swinton buildings is fitted as part of the job, not as an afterthought. Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Swinton we replace them with hardware covered by each door's evidence.
Why hardware choice matters
Fire doors are tested with particular hardware. Hinges hold the door in place as it heats up; locks and latches keep it shut against fire pressure; their holes are protected with intumescent linings. Swapping in a cheaper hinge, a larger lock body or a lever on a spindle that melts can change how the door behaves. Hinges for fire doors are commonly grade 13 to BS EN 1935.
Each installation includes:
- Locks and latches covered by the evidence
- Bolts and selectors where specified
- Lever handles, pull handles and push plates
- Fire-rated hinges, commonly grade 13
Fire door law for Swinton properties
The rules that apply to fire doors in Swinton are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Swinton block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Buildings and duty holders in Swinton
Landlords, managing agents, facilities teams and homeowners in Swinton can all commission fire door ironmongery from us. The usual settings are hotels and schools, though single doors for HMOs are just as welcome.
How a Swinton job runs
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Prices for fire door ironmongery in Swinton
As a guide, budget from £40 for minor items to £350 for a full hardware set per door, ex VAT for fire door ironmongery. The figure for your Swinton building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Swinton and neighbouring towns
Neighbouring towns such as Eccles, Walkden, Salford and Urmston are covered too, so clients with several buildings can use one installer and one evidence format.
Questions from Swinton
Do you cover M27 and nearby postcodes?
Yes. We cover Swinton including M27, and nearby towns such as Eccles and Walkden. The survey and written quote are free.
How quickly can you survey in Swinton?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
How many hinges does a fire door need?
Usually at least three, of the type and grade specified in the door's evidence. Heavier or taller doors may need more.
Are brass hinges acceptable on fire doors?
Only if they are fire tested and covered by the door's evidence. Many decorative hinges are not.