FD60 fire doors in Salisbury

FD60 fire doors in Salisbury: what's involved

From the SP1 postcode district outwards, we take on FD60 fire doors across Salisbury for homes, blocks and workplaces.

Around Salisbury, small offices, light industrial buildings and family homes after loft conversions all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

FD60 openings in Salisbury buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. For FD60 work in Salisbury we generally fit certified doorsets, so frame and leaf share the same test evidence.

When does a building need FD60 rather than FD30?

FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.

We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.

What you get:

• Intumescent and smoke seals as specified
• Check of the fire strategy rating for each opening
• Frame fixing and structural gap sealing recorded with photos
• Load-rated hinges and correctly powered closer

Rules and responsibilities in Salisbury

The rules that apply to fire doors in Salisbury are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.

Where a Salisbury block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.

Who needs FD60 fire doors in Salisbury?

You are most likely to need FD60 fire doors if you look after refuse stores, stair cores in taller blocks or mixed-use commercial buildings. Whatever the building in Salisbury, we survey each opening and tell you which doors need work and which do not.

The steps on a Salisbury installation

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Budgeting for FD60 fire doors in Salisbury

As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Salisbury building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Around Salisbury

Salisbury is about 54.3 km from Swindon, and we cover both, along with nearby Andover and Totton. Send us your postcode and we'll confirm survey dates.

Questions from Salisbury