FD60 fire doors in Lofthouse: what's involved
Our FD60 fire doors service covers Lofthouse and the wider West Yorkshire area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
Fire doors in Lofthouse protect escape routes in schools, houses with integral garages and family homes after loft conversions alike. We adapt the programme to the building and its occupants, never the standard of the installation.
FD60 openings in Lofthouse buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. Before ordering FD60 doors for a Lofthouse building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer.
When does a building need FD60 rather than FD30?
FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.
We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.
On a typical job that means:
- Intumescent and smoke seals as specified
- Certified FD60 doorset or leaf with matching evidence
- Check of the fire strategy rating for each opening
- Load-rated hinges and correctly powered closer
Which fire door rules apply in Lofthouse?
The rules that apply to fire doors in Lofthouse are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Lofthouse block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Which buildings in Lofthouse need FD60 fire doors?
Landlords, managing agents, facilities teams and homeowners in Lofthouse can all commission FD60 fire doors from us. The usual settings are stair cores in taller blocks and mixed-use commercial buildings, though single doors for refuse stores are just as welcome.
The steps on a Lofthouse installation
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
What does FD60 fire doors cost in Lofthouse?
If you need a budget figure first, the guide for FD60 fire doors is £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Around Lofthouse
We also cover towns near Lofthouse, including Wakefield (5.1 km away), Morley and Ossett. If your building is in WF3 or a neighbouring district, the service and pricing are the same.
Common questions
Do you work in Lofthouse?
Yes, we take on FD60 fire doors in Lofthouse and the surrounding area, including Wakefield and Morley. Send your postcode and a few details and we'll come back with survey dates.
What happens on a survey in Lofthouse?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.

