FD60 fire doors for Hamilton buildings
When you book FD60 fire doors in Hamilton, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
Fire doors in Hamilton protect escape routes in HMOs, low-rise blocks of flats and houses with integral garages alike. We adapt the programme to the building and its occupants, never the standard of the installation.
For FD60 work in Hamilton we generally fit certified doorsets, so frame and leaf share the same test evidence. FD60 openings in Hamilton buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.
When does a building need FD60 rather than FD30?
FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.
We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.
On a typical job that means:
- Frame fixing and structural gap sealing recorded with photos
- Check of the fire strategy rating for each opening
- Certified FD60 doorset or leaf with matching evidence
- Load-rated hinges and correctly powered closer
Rules and responsibilities in Hamilton
In Hamilton, fire doors are specified against Scotland's Technical Handbooks (Section 2: Fire) under the Building (Scotland) Regulations 2004, rather than Approved Document B. Duties in non-domestic premises come from the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006.
England's regulation 10 does not apply in Scotland. We follow the building's fire risk assessment and, where building work needs a warrant, the local authority's requirements.
Buildings and duty holders in Hamilton
The need for FD60 fire doors usually arises in refuse stores or stair cores in taller blocks, and sometimes mixed-use commercial buildings. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Hamilton to keep escape routes protected throughout.
The steps on a Hamilton installation
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Prices for FD60 fire doors in Hamilton
If you need a budget figure first, the guide for FD60 fire doors is £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Nearby areas we cover from Hamilton
Hamilton is about 9.0 km from East Kilbride, and we cover both, along with nearby Motherwell and Wishaw. Send us your postcode and we'll confirm survey dates.
Questions
Do you cover ML3 and nearby postcodes?
Yes. We cover Hamilton including ML3, and nearby towns such as Motherwell and Wishaw. The survey and written quote are free.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.