FD60 fire doors: our service in Bristol
Our FD60 fire doors service covers all of Bristol, across postcode districts including BS1, BS99 and BS8.
Before ordering FD60 doors for a Bristol building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Bristol we generally fit certified doorsets, so frame and leaf share the same test evidence.
Bristol has a mix of buildings, from purpose-built blocks to converted houses and commercial premises. We tailor the programme to the building, not the other way round.
Why FD60 installation is less forgiving
A 54mm leaf can weigh considerably more than a 44mm one. That weight drives everything else: more robust frames and fixings, hinges rated for the load, and a closer with enough power to close and latch the door without making it too heavy to open. Glazing, if any, must use a 60-minute glass and glazing system from the same test evidence.
Because of this, most FD60 openings are best done as a certified doorset, so the frame and leaf come with matching evidence.
Which fire door rules apply in Bristol?
Fire doors in Bristol fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Bristol above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
From enquiry to handover in Bristol
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Guide prices in Bristol
Budget around £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. Our guide prices are the same in Bristol as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.
Common questions
Do you provide FD60 fire doors across Bristol?
Yes. We cover all of Bristol. Surveys and written quotes are free.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.