What FD60 fire doors in Ayr should include
Looking for FD60 fire doors in Ayr? We supply and fit certified fire doors and components across Ayr and the wider Ayrshire area, working from a free survey and a fixed written quote.
Around Ayr, family homes after loft conversions, schools and light industrial buildings all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Before ordering FD60 doors for a Ayr building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. For FD60 work in Ayr we generally fit certified doorsets, so frame and leaf share the same test evidence.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
Each installation includes:
- Check of the fire strategy rating for each opening
- 60-minute glazing systems where vision panels are needed
- Frame fixing and structural gap sealing recorded with photos
- Intumescent and smoke seals as specified
Fire door law for Ayr properties
In Ayr, fire doors are specified against Scotland's Technical Handbooks (Section 2: Fire) under the Building (Scotland) Regulations 2004, rather than Approved Document B. Duties in non-domestic premises come from the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006.
England's regulation 10 does not apply in Scotland. We follow the building's fire risk assessment and, where building work needs a warrant, the local authority's requirements.
Which buildings in Ayr need FD60 fire doors?
You are most likely to need FD60 fire doors if you look after stair cores in taller blocks, plant and boiler rooms or mixed-use commercial buildings. Whatever the building in Ayr, we survey each opening and tell you which doors need work and which do not.
How a Ayr job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
What does FD60 fire doors cost in Ayr?
If you need a budget figure first, the guide for FD60 fire doors is £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Nearby areas we cover from Ayr
Neighbouring towns such as Irvine, Kilmarnock, Newton Mearns and Paisley are covered too, so clients with several buildings can use one installer and one evidence format.
Common questions
Is Ayr within your coverage area?
It is. We cover Ayr in Ayrshire and neighbouring towns such as Irvine. There is no charge for the survey.
How quickly can you survey in Ayr?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.