FD30 fire doors in Bromsgrove

Getting FD30 fire doors right in Bromsgrove

We provide FD30 fire doors in Bromsgrove (B61 and the surrounding postcodes), from the first survey through to a documented handover.

In and around Bromsgrove, fire door work covers everything from small offices to houses with integral garages. We plan each job around the people who use the building.

In Bromsgrove, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Bromsgrove is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

As standard, the work covers:

• Intumescent strips and smoke seals to the certification
• Fire-tested hinges, latch or lock and intumescent pads
• Photo record, product data and certificate references at handover
• Certified FD30 or FD30S leaf, or full doorset

Rules and responsibilities in Bromsgrove

The rules that apply to fire doors in Bromsgrove are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.

Where a Bromsgrove block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.

Buildings and duty holders in Bromsgrove

Typical settings for FD30 fire doors include HMOs, blocks of flats and shops. In Bromsgrove, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

How a Bromsgrove job runs

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Bromsgrove?

If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.

Bromsgrove and neighbouring towns

Bromsgrove is about 19.6 km from Worcester, and we cover both, along with nearby Redditch and Droitwich. Send us your postcode and we'll confirm survey dates.

Common questions