FD30 fire doors in Burgess Hill

FD30 fire doors: our service in Burgess Hill

From the RH15 postcode district outwards, we take on FD30 fire doors across Burgess Hill for homes, blocks and workplaces.

Buildings in and around Burgess Hill range from houses with integral garages to family homes after loft conversions and small blocks of flats. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

In Burgess Hill, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Burgess Hill is sized for the opening, rather than trimmed beyond what its certification allows.

Leaf only or a full doorset?

If the existing frame is sound, correctly sized, securely fixed and compatible with the new leaf's certification, a new FD30 leaf can be hung in it. Many frames do not pass that test: old softwood linings, frames that have been cut about for previous doors, or frames with no evidence of how they were fixed. In those cases a certified doorset (leaf, frame and ironmongery tested together) is the cleaner answer and usually the quicker one on site.

We tell you which route each opening needs on the survey, door by door, and why.

On a typical job that means:

• Certified FD30 or FD30S leaf, or full doorset
• Survey of the opening, frame and existing ironmongery
• Frame-to-wall gap sealed with an evidenced material
• Fire-tested hinges, latch or lock and intumescent pads

Which fire door rules apply in Burgess Hill?

Fire doors in Burgess Hill fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Burgess Hill above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Where FD30 fire doors fit in Burgess Hill

Landlords, managing agents, facilities teams and homeowners in Burgess Hill can all commission FD30 fire doors from us. The usual settings are HMOs and care homes, though single doors for blocks of flats are just as welcome.

What happens after you enquire

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Burgess Hill?

As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Burgess Hill building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Nearby areas we cover from Burgess Hill

Burgess Hill is about 17.5 km from Crawley, and we cover both, along with nearby Haywards Heath and Portslade. Send us your postcode and we'll confirm survey dates.

Questions from Burgess Hill