FD30 fire doors in Isle of Wight, done to the evidence
Across Isle of Wight, from Newport (Isle of Wight) to Ryde, we survey, supply and fit FD30 fire doors for homes, blocks of flats and workplaces.
In Isle of Wight, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Isle of Wight is sized for the opening, rather than trimmed beyond what its certification allows.
Fire door work in Isle of Wight spans housing providers with large estates, individual landlords, businesses and homeowners. We price every job from a survey, never from a list price alone, because the condition of the frames and the hardware makes a real difference.
Leaf only or a full doorset?
If the existing frame is sound, correctly sized, securely fixed and compatible with the new leaf's certification, a new FD30 leaf can be hung in it. Many frames do not pass that test: old softwood linings, frames that have been cut about for previous doors, or frames with no evidence of how they were fixed. In those cases a certified doorset (leaf, frame and ironmongery tested together) is the cleaner answer and usually the quicker one on site.
We tell you which route each opening needs on the survey, door by door, and why.
What the rules say for Isle of Wight
In Isle of Wight, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Isle of Wight building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
From enquiry to handover in Isle of Wight
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Guide prices in Isle of Wight
Guide pricing for FD30 fire doors: £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. Volume work across several doors in one Isle of Wight building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Common questions
Do you provide FD30 fire doors across Isle of Wight?
Yes. We cover all of Isle of Wight, including Newport (Isle of Wight) and Ryde. Surveys and written quotes are free.
What is the difference between FD30 and FD30S?
FD30S has been tested for smoke control as well as fire. It adds a smoke seal, usually a brush or blade, and needs a tight threshold gap. Flat entrance doors and doors onto protected escape routes are commonly specified as FD30S.
Do FD30 doors need a closer?
Most do. Doors on escape routes, flat entrance doors and doors in the common parts of buildings need a self-closing device that shuts and latches the door. Some doors inside houses and locked riser doors are exceptions, depending on the fire strategy.