FD30 fire doors in Stevenage, SG1

What FD30 fire doors in Stevenage should include

From the SG1 postcode district outwards, we take on FD30 fire doors across Stevenage for homes, blocks and workplaces.

Around Stevenage, low-rise blocks of flats, family homes after loft conversions and industrial estates all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

In Stevenage, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. For a mixed portfolio in Stevenage, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

On a typical job that means:

• Certified FD30 or FD30S leaf, or full doorset
• Fire-tested hinges, latch or lock and intumescent pads
• Photo record, product data and certificate references at handover
• Frame-to-wall gap sealed with an evidenced material

The regulations behind fire doors in Stevenage

Fire doors in Stevenage fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Stevenage above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Buildings and duty holders in Stevenage

The need for FD30 fire doors usually arises in HMOs or shops, and sometimes care homes. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Stevenage to keep escape routes protected throughout.

The steps on a Stevenage installation

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

What does FD30 fire doors cost in Stevenage?

Budget around £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. Our guide prices are the same in Stevenage as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.

Nearby areas we cover from Stevenage

Nearby towns we cover include Hitchin, Letchworth Garden City and Welwyn Garden City. Distance from Stevenage does not change our guide prices, and the survey and quote are free.

Common questions