FD30 fire doors: our service in Ayrshire
Our FD30 fire doors service runs throughout Ayrshire. Main towns include Kilmarnock, Ayr and Irvine, and we cover the smaller places in between.
For a mixed portfolio in Ayrshire, we can survey every FD30 opening in one visit and price leaf-only and doorset options side by side. Each FD30 leaf we supply for Ayrshire is sized for the opening, rather than trimmed beyond what its certification allows.
Ayrshire has a mix of buildings, from purpose-built blocks to converted houses and commercial premises. We tailor the programme to the building, not the other way round.
What does a correct FD30 installation include?
A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.
Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.
Rules and responsibilities in Ayrshire
Ayrshire is in Scotland, which has its own system. Building work, including many fire door replacements, is governed by the Building (Scotland) Regulations 2004 and the Technical Handbooks, with Section 2 covering fire; where a building warrant is needed it comes from the local authority. In non-domestic premises, the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006 set the duties.
The common parts of private blocks of flats largely sit outside Part 3 of the 2005 Act, so the fire risk assessment and housing obligations usually drive fire door work in residential buildings in Ayrshire.
From enquiry to handover in Ayrshire
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Guide prices in Ayrshire
If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Common questions
Do you provide FD30 fire doors across Ayrshire?
Yes. We cover all of Ayrshire, including Kilmarnock and Ayr. Surveys and written quotes are free.
Do FD30 doors need a closer?
Most do. Doors on escape routes, flat entrance doors and doors in the common parts of buildings need a self-closing device that shuts and latches the door. Some doors inside houses and locked riser doors are exceptions, depending on the fire strategy.
Can a new FD30 door go into my old frame?
Sometimes. The frame has to be sound, square, securely fixed and compatible with the new leaf's certification. Many older frames are not, especially softwood linings or frames altered for previous doors. We check each frame on the survey and recommend a doorset only where the frame cannot be relied on.