Riser and cupboard fire doors in Gateshead, done to the evidence
From the NE8 postcode district outwards, we take on riser and cupboard fire doors across Gateshead for homes, blocks and workplaces.
Buildings in and around Gateshead range from industrial estates to low-rise blocks of flats and houses with integral garages. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
While fitting riser doors in Gateshead, we photograph any gaps in fire stopping we can see and pass them on to you. Riser and meter cupboard doors in Gateshead blocks are easy to overlook until an inspection flags them.
The fire stopping behind the door
The door is only half the picture. Inside the riser, the services passing through each floor must be fire stopped. That is a separate specialist task. Where we find gaps or missing fire stopping while fitting riser doors, we record it and flag it to you so it can be addressed.
As standard, the work covers:
- Record of any fire stopping concerns found
- Locks and keep-locked arrangements as specified
- Single and double flush configurations
- Seals and frame gap sealing
Which fire door rules apply in Gateshead?
The rules that apply to fire doors in Gateshead are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Gateshead block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where riser and cupboard fire doors fit in Gateshead
The need for riser and cupboard fire doors usually arises in blocks of flats or student accommodation, and sometimes office buildings. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Gateshead to keep escape routes protected throughout.
How a Gateshead job runs
- Survey risers, cupboards and wall ratings
- Confirm locked-shut or self-closing for each door
- Order doorsets sized to the openings
- Install and seal frames, hang leaves
- Fit locks, seals and signage
- Photograph and report on visible fire stopping
Prices for riser and cupboard fire doors in Gateshead
As a guide, budget £450–£1,200 per riser or cupboard doorset supplied and fitted, ex VAT for riser and cupboard fire doors. The figure for your Gateshead building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Gateshead
Neighbouring towns such as Newcastle upon Tyne, Felling, Gosforth and Wallsend are covered too, so clients with several buildings can use one installer and one evidence format.
Questions
Do you cover NE8 and nearby postcodes?
Yes. We cover Gateshead including NE8, and nearby towns such as Newcastle upon Tyne and Felling. The survey and written quote are free.
What happens on a survey in Gateshead?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Do riser doors need closers?
Not if they are kept locked shut and the fire strategy allows it; they should then be labelled accordingly. Cupboards that are opened regularly normally need self-closers.
What rating should a riser door be?
It should match the fire resistance the strategy requires for the riser enclosure, commonly 30 or 60 minutes. We confirm it before ordering.