Riser and cupboard fire doors in Christchurch: what's involved
Our riser and cupboard fire doors service covers Christchurch and the wider Dorset area. Every job starts with a survey of the openings, so the quote reflects your actual doors rather than a guess.
Buildings in and around Christchurch range from care homes to small offices and schools. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
Riser and meter cupboard doors in Christchurch blocks are easy to overlook until an inspection flags them. While fitting riser doors in Christchurch, we photograph any gaps in fire stopping we can see and pass them on to you.
The fire stopping behind the door
The door is only half the picture. Inside the riser, the services passing through each floor must be fire stopped. That is a separate specialist task. Where we find gaps or missing fire stopping while fitting riser doors, we record it and flag it to you so it can be addressed.
As standard, the work covers:
- Signage as required
- Record of any fire stopping concerns found
- Fire-rated riser and cupboard doorsets
- Seals and frame gap sealing
Fire door law for Christchurch properties
Fire doors in Christchurch fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Christchurch above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Which buildings in Christchurch need riser and cupboard fire doors?
You are most likely to need riser and cupboard fire doors if you look after office buildings, student accommodation or hotels. Whatever the building in Christchurch, we survey each opening and tell you which doors need work and which do not.
From enquiry to handover in Christchurch
- Survey risers, cupboards and wall ratings
- Confirm locked-shut or self-closing for each door
- Order doorsets sized to the openings
- Install and seal frames, hang leaves
- Fit locks, seals and signage
- Photograph and report on visible fire stopping
Prices for riser and cupboard fire doors in Christchurch
Guide pricing for riser and cupboard fire doors: £450–£1,200 per riser or cupboard doorset supplied and fitted, ex VAT. Volume work across several doors in one Christchurch building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Nearby areas we cover from Christchurch
Christchurch is about 7.1 km from Bournemouth, and we cover both, along with nearby New Milton and Poole. Send us your postcode and we'll confirm survey dates.
Questions from Christchurch
Is Christchurch within your coverage area?
It is. We cover Christchurch in Dorset and neighbouring towns such as Bournemouth. There is no charge for the survey.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
Do you fix fire stopping inside risers?
Fire stopping is a separate specialist trade. We record anything we see while fitting doors and can coordinate with your fire stopping contractor.
What rating should a riser door be?
It should match the fire resistance the strategy requires for the riser enclosure, commonly 30 or 60 minutes. We confirm it before ordering.