Certified fire doorsets in Irvine, done to the evidence
We provide certified fire doorsets in Irvine (KA12 and the surrounding postcodes), from the first survey through to a documented handover.
Buildings in and around Irvine range from small blocks of flats to light industrial buildings and houses with integral garages. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
Doorsets suit refurbishment programmes in Irvine, where several openings can be measured, ordered and fitted in one planned sequence. Every doorset we fit in Irvine is handed over with its certificate reference and photographs of the frame fixing and gap sealing.
What does third-party certification mean?
Third-party certification means an independent body has checked the product's test evidence and audits the factory that makes it. Certified products carry a label or plug on the door edge and a certificate you can check. Buyers often look for schemes such as BWF Certifire or BM TRADA Q-Mark when choosing products. Our guide to certified doorsets explains how to read the label and certificate.
On a typical job that means:
- Installation to the manufacturer's instructions
- Frame fixing and frame-to-wall gap sealing
- Doorset selection to rating, size and use
- Certificate references and photo record per opening
What the rules say for Irvine
In Irvine, fire doors are specified against Scotland's Technical Handbooks (Section 2: Fire) under the Building (Scotland) Regulations 2004, rather than Approved Document B. Duties in non-domestic premises come from the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006.
England's regulation 10 does not apply in Scotland. We follow the building's fire risk assessment and, where building work needs a warrant, the local authority's requirements.
Where certified fire doorsets fit in Irvine
Landlords, managing agents, facilities teams and homeowners in Irvine can all commission certified fire doorsets from us. The usual settings are refurbishment programmes and schools and offices, though single doors for blocks of flats are just as welcome.
The steps on a Irvine installation
- Survey and measure every structural opening
- Specify doorsets by rating, size, hand, finish and hardware
- Prepare openings and remove existing doors and linings
- Fix and seal the frames to the structure
- Hang, adjust and test each leaf and closer
- Fit architraves, make good and hand over evidence
Guide prices in Irvine
If you need a budget figure first, the guide for certified fire doorsets is £650–£1,300 for an FD30 doorset and £850–£1,800 for FD60, supplied and fitted, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Covering Irvine and nearby
We also cover towns near Irvine, including Kilmarnock (10.0 km away), Ayr and Newton Mearns. If your building is in KA12 or a neighbouring district, the service and pricing are the same.
Common questions
Do you cover KA12 and nearby postcodes?
Yes. We cover Irvine including KA12, and nearby towns such as Kilmarnock and Ayr. The survey and written quote are free.
What happens on a survey in Irvine?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Are doorsets more expensive than a leaf?
The product costs more, but the labour is often lower and the result is better evidenced. Where a frame would need replacing anyway, a doorset is usually the better value.
Can a doorset be fitted into an existing opening?
Usually, yes. Doorsets are made to fit the structural opening once the old frame is removed. We measure the opening on the survey so the doorset is made to the right size and the gaps to the wall stay within what the evidence allows.