Fire door ironmongery in Crawley: what's involved
When you book fire door ironmongery in Crawley, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
Buildings in and around Crawley range from HMOs to purpose-built flats and schools. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Crawley we replace them with hardware covered by each door's evidence. Signage for fire doors in Crawley buildings is fitted as part of the job, not as an afterthought.
Why hardware choice matters
Fire doors are tested with particular hardware. Hinges hold the door in place as it heats up; locks and latches keep it shut against fire pressure; their holes are protected with intumescent linings. Swapping in a cheaper hinge, a larger lock body or a lever on a spindle that melts can change how the door behaves. Hinges for fire doors are commonly grade 13 to BS EN 1935.
On a typical job that means:
- Lever handles, pull handles and push plates
- Intumescent pads and lock linings
- Fire door signage
- Fire-rated hinges, commonly grade 13
Rules and responsibilities in Crawley
Fire doors in Crawley fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Crawley above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Which buildings in Crawley need fire door ironmongery?
Landlords, managing agents, facilities teams and homeowners in Crawley can all commission fire door ironmongery from us. The usual settings are HMOs and schools, though single doors for offices are just as welcome.
The steps on a Crawley installation
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Budgeting for fire door ironmongery in Crawley
As a guide, budget from £40 for minor items to £350 for a full hardware set per door, ex VAT for fire door ironmongery. The figure for your Crawley building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Crawley
Beyond Crawley itself we also cover nearby towns such as Horley (7.0 km), Horsham and East Grinstead. The service, pricing and evidence are the same wherever you are.
Common questions
Do you work in Crawley?
Yes, we take on fire door ironmongery in Crawley and the surrounding area, including Horley and Horsham. Send your postcode and a few details and we'll come back with survey dates.
What happens on a survey in Crawley?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Can I fit a new lock to a fire door?
Only one that is covered by the door's test evidence, fitted with the correct intumescent protection. A larger lock body or new holes can compromise the door.
How many hinges does a fire door need?
Usually at least three, of the type and grade specified in the door's evidence. Heavier or taller doors may need more.