Fire door ironmongery in Romford: what's involved
We provide fire door ironmongery in Romford (RM1 and the surrounding postcodes), from the first survey through to a documented handover.
Around Romford, schools, hotels and clinics all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Signage for fire doors in Romford buildings is fitted as part of the job, not as an afterthought. Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Romford we replace them with hardware covered by each door's evidence.
Why hardware choice matters
Fire doors are tested with particular hardware. Hinges hold the door in place as it heats up; locks and latches keep it shut against fire pressure; their holes are protected with intumescent linings. Swapping in a cheaper hinge, a larger lock body or a lever on a spindle that melts can change how the door behaves. Hinges for fire doors are commonly grade 13 to BS EN 1935.
What you get:
- Lever handles, pull handles and push plates
- Bolts and selectors where specified
- Fire-rated hinges, commonly grade 13
- Locks and latches covered by the evidence
Fire door law for Romford properties
In Romford, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet. Enforcement of fire safety law in Romford sits with the London Fire Brigade.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Romford building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Which buildings in Romford need fire door ironmongery?
From schools to blocks of flats, the requirement for fire door ironmongery in Romford comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.
The steps on a Romford installation
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Prices for fire door ironmongery in Romford
Guide pricing for fire door ironmongery: from £40 for minor items to £350 for a full hardware set per door, ex VAT. Volume work across several doors in one Romford building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Around Romford
We also cover towns near Romford, including Hornchurch (2.9 km away), Dagenham and Becontree. If your building is in RM1 or a neighbouring district, the service and pricing are the same.
Questions from Romford
Do you work in Romford?
Yes, we take on fire door ironmongery in Romford and the surrounding area, including Hornchurch and Dagenham. Send your postcode and a few details and we'll come back with survey dates.
What happens on a survey in Romford?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Are brass hinges acceptable on fire doors?
Only if they are fire tested and covered by the door's evidence. Many decorative hinges are not.
Do fire doors need signs?
Most fire doors in non-domestic buildings and common parts should carry signage showing whether they are to be kept shut, kept locked or are automatic.