What fire door ironmongery in Cheshire should include
Whether your building is in Warrington, Chester or a smaller place in Cheshire, we can provide fire door ironmongery with the same evidence-led approach.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Cheshire we replace them with hardware covered by each door's evidence. Signage for fire doors in Cheshire buildings is fitted as part of the job, not as an afterthought.
Wherever your building is in Cheshire, the fire safety duties come from national rules, and our installation standard is the same.
Why hardware choice matters
Fire doors are tested with particular hardware. Hinges hold the door in place as it heats up; locks and latches keep it shut against fire pressure; their holes are protected with intumescent linings. Swapping in a cheaper hinge, a larger lock body or a lever on a spindle that melts can change how the door behaves. Hinges for fire doors are commonly grade 13 to BS EN 1935.
Which fire door rules apply in Cheshire?
In Cheshire, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Cheshire building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
The steps on a Cheshire installation
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
Guide prices in Cheshire
If you need a budget figure first, the guide for fire door ironmongery is from £40 for minor items to £350 for a full hardware set per door, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Questions
Do you provide fire door ironmongery across Cheshire?
Yes. We cover all of Cheshire, including Warrington and Chester. Surveys and written quotes are free.
Do fire doors need signs?
Most fire doors in non-domestic buildings and common parts should carry signage showing whether they are to be kept shut, kept locked or are automatic.
Can I fit a new lock to a fire door?
Only one that is covered by the door's test evidence, fitted with the correct intumescent protection. A larger lock body or new holes can compromise the door.